News — scanning

Why the CS-Lite color modes are important for camera scanning

Posted by CineStill on

The real secret to a workable camera scan is getting a good initial capture in camera so that you don’t have to push or stretch the file more than it's bit depth or the software can handle. This means getting an appropriate exposure and color balance at the moment of capture. 

With the new CS-LITE, there are 3 color modes built in: Warm for slides, White for black and white film, and Cool mode for color negatives. So for this post, we’re putting all 3 color modes to the test to show you the difference. 

Raw Capturewhat your capture will look like with the three different color modes when you set your white balance to the coolest setting at 2000 kelvinCool | White | Warm

Due to the orange mask which is present when scanning color negatives, using any other scanning light source (or our CS-LITE set to the White light mode), you will need to do more than just invert the negative with added contrast and adjust color temperature further for good color, resulting in the need to use the fringes of what the sensors is capable of recording, similar to underexposing or blowing your highlights by overexposing your capture, but only in one or two color channels. RAW files are fantastic if you miss exposure a little bit, but there are limits. For example, you don’t want to underexpose your capture too much or you will see a lot of noise and contrast and color will be hard to control.

Inverted with LR CurvesWhat we could get using minimal adjustments in Lightroom to convertCool | White | Warm

It needed hardly any RGB midpoint correction to adjust for the Cool setting and likely only because this was 800T in open shade, otherwise I would have been able to correct color using only white balance if it were shot on 400D or with an 85 warming filter on the lens. It is very apparent that the White and Warm light modes require quite a bit more adjustment, even when adjusting the RGB midpoints in tone curves...

Read more →






The VALOI 360 Camera Scanning System — Now Available in North America

Posted by CineStill on

We are pleased to announce that the Valoi 360 Camera scanning system is now available in North America through CineStillFilm.com.

Read more →